Logo

ISO 2493-2:2020

Current Revision

Paper and board - Determination of resistance to bending - Part 2: Taber-type tester

$81.00

$81.00

$137.70


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Document Preview Not Available...

This document specifies procedures to measure the bending resistance of paper and paperboard using a Taber-type tester.

This document is used to determine the bending moment required to deflect the free end of a 38 mm wide vertically clamped specimen by 15° when the load is applied at a bending length of 50 mm. For boards that tend to be permanently deformed if bent through 15°, the half bending angle, i.e. 7,5°, can be used. The bending resistance is expressed in terms of the bending moment and parameters set by the manufacturer of the Taber-type tester.

The method is primarily used for papers with a high grammage.

NOTE This document does not cover the low-range version of the Taber-type instrument that uses a bending length of 10 mm (see Reference [5]).


SDO ISO: International Organization for Standardization
Document Number ISO 2493
Publication Date Not Available
Language en - English
Page Count
Revision Level
Supercedes
Committee ISO/TC 6/SC 2
Publish Date Document Id Type View
Not Available ISO 2493-2:2020 Revision