Logo

CSA C22.2 NO. 211.2:26

Current Revision

Rigid PVC (unplasticized) conduit

$700.00

$700.00

$1,260.00


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Document Preview Not Available...

Rigid PVC (unplasticized) conduit

Preface

This is the third edition of CSA C22.2 No. 211.2, Rigid PVC (unplasticized) conduit , one of a series of Standards issued by the Canadian Standards Association under Part II of the Canadian Electrical Code. It supersedes the previous editions published in 2006 and 1984. The following are the major changes to this edition

  1. added definitions for post-industrial (pre-consumer), reconstituted, recovered, and post-consumer PVC materials in Clause 3
  2. updated the requirements for alternative construction for conduit consisting of non-virgin compounds in Clauses 4.2.2 to 4.2.4 and 5.1
  3. added requirements for angled moulded couplings in Clauses 5.2.1, 6.2, 7.4.2, Table 2, and Figure 6
  4. updated the tolerance for relative humidity in Clause 7.1
  5. updated the requirements for the impact resistance test to add a referee method in Clause 7.4.3
  6. updated the requirements for the resistance to sag test in Clause 7.5
  7. and updated the requirements for the weather resistance test in Clauses 7.9.2 and 7.9.4.

This Standard is considered suitable for use for conformity assessment within the stated scope of the Standard. This Standard was prepared by the Integrated Committee on Nonmetallic Conduit, Tubing, and Fittings, under the jurisdiction of the Technical Committee on Wiring Products and the Strategic Steering Committee on Requirements for Electrical Safety, and has been formally approved by the Technical Committee. This Standard has been developed in compliance with Standards Council of Canada requirements for National Standards of Canada. It has been published as a National Standard of Canada by CSA Group

Scope
1.1

This Standard applies to rigid PVC (unplasticized) conduit, elbows, bends, and couplings, intended for use at a continuous operating temperature of 75 °C, for the installation of wires and cables in accordance with the Rules of the Canadian Electrical Code, Part I, for ordinary locations.

1.2

The products covered by this Standard are not threaded and are intended to be joined together by couplings using a suitable solvent cement.

1.3

In this Standard, "shall" is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the Standard; "should" is used to express a recommendation or that which is advised but not required; and "may" is used to express an option or that which is permissible within the limits of the Standard. Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material. Notes to tables and figures are considered part of the table or figure and may be written as requirements. Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application.

1.4

The values given in SI units are the units of record for the purposes of this Standard. The values given in parentheses are for information and comparison only.


SDO CSA: Canadian Standards Association
Document Number
Publication Date Jan. 1, 2026
Language en - English
Page Count 35
Revision Level
Supercedes
Committee
Publish Date Document Id Type View
Jan. 1, 2026 CSA C22.2 NO. 211.2:26 Revision
Jan. 1, 2006 CSA C22.2 NO. 211.2:06 (R2021) Revision