Logo

CSA/ANSI Z21.91:20 (R2024)

Current Revision

Ventless firebox enclosures for gas-fired unvented gas log type room heaters

$590.00


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Document Preview Not Available...

Ventless firebox enclosures for gas-fired unvented gas log type room heaters
Preface This is the fourth edition of CSA/ANSI Z21.91, Ventless firebox enclosures for gas-fired unvented gas log type room heaters . It supersedes the previous editions published in 2017, 2007, and 2001. This Standard is considered suitable for use for conformity assessment within the stated scope of the Standard. This Standard was prepared by the Joint Subcommittee on Unvented Gas-Fired Heating Appliances, under the jurisdiction of the Z21/83 Technical Committee on Performance and Installation of Gas Burning Appliances and Related Accessories and the Strategic Steering Committee on Fuels and Appliances. It has been formally approved by the Z21/83 Technical Committee on Performance and Installation of Gas Burning Appliances and Related Accessories. This Standard has been approved by the American National Standards Institute (ANSI) as an American National Standard. Scope 1.1 This Standard applies to newly produced ventless firebox enclosures (see Clause 3, Definitions), herein after referred to as fireboxes, for unvented gas log type room heaters. 1.2 Fireboxes covered by this Standard are intended for use with unvented room heaters that comply with ANSI Z21.11.2 for installation in solid fuel-burning fireplaces. 1.3 If a value for measurement as given in this Standard is followed by an equivalent value in other units, the first stated value is to be regarded as the specification. 1.4 All references to "psi" throughout this Standard are to be considered gauge pressures, unless otherwise specified. 1.5 In this Standard, "shall" is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the standard; "should" is used to express a recommendation or that which is advised but not required; and "may" is used to express an option or that which is permissible within the limits of the Standard. Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material. Notes to tables and figures are considered part of the table or figure and may be written as requirements. Annexes are designated normative (mandatory) or informative (nonmandatory) to define their application.

SDO CSA: Canadian Standards Association
Document Number
Publication Date Jan. 1, 2020
Language en - English
Page Count
Revision Level
Supercedes
Committee
Publish Date Document Id Type View
Jan. 1, 2020 CSA/ANSI Z21.91:20 (R2024) Revision