Logo

ASTM F996-98(2003)

Current Reaffirmation

Standard Test Method for Separating an Ionizing Radiation-Induced MOSFET Threshold Voltage Shift Into Components Due to Oxide Trapped Holes and Interface States Using the Subthreshold Current–Voltage Characteristics (Withdrawn 2023)

$83.00

$83.00

$149.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


...

1.1 This test method covers the use of the subthreshold charge separation technique for analysis of ionizing radiation degradation of a gate dielectric in a metal-oxide-semiconducter-field-effect transistor (MOSFET) and an isolation dielectic in a parasitic MOSFET. The subthreshold technique is used to separate the ionizing radiation-induced inversion voltage shift, V INV into voltage shifts due to oxide trapped charge, Vot and interface traps, Vit. This technique uses the pre- and post-irradiation drain to source current versus gate voltage characteristics in the MOSFET subthreshold region.

1.2 Procedures are given for measuring the MOSFET subthreshold current-voltage characteristics and for the calculation of results.

1.3 The application of this test method requires the MOSFET to have a substrate (body) contact.

1.4 Both pre- and post-irradiation MOSFET subthreshold source or drain curves must follow an exponential dependence on gate voltage for a minimum of two decades of current.

1.5 The values given in SI units are to be regarded as standard. No other units of measurement are included in this test method.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


The electrical properties of gate and field oxides are altered by ionizing radiation. The time dependent and dose rate effects of the ionizing radiation can be determined by comparing pre- and post-irradiation voltage shifts, ΔVot andΔ Vit. This test method provides a means for evaluation of the ionizing radiation response of MOSFETs and isolation parasitic MOSFETs.

The measured voltage shifts, ΔVot andΔ Vit, can provide a measure of the effectiveness of processing variations on the ionizing radiation response.

This technique can be used to monitor the total-dose response of a process technology.

SDO ASTM: ASTM International
Document Number F996
Publication Date May 10, 1998
Language en - English
Page Count 7
Revision Level 98(2003)
Supercedes
Committee F01.11
Publish Date Document Id Type View
March 1, 2018 F0996-11R18 Revision
Jan. 1, 2011 F0996-11 Revision
May 1, 2010 F0996-10 Revision
May 10, 1998 F0996-98 Revision
May 10, 1998 F0996-98R03 Reaffirmation