Logo

ASTM F468M-06(2018)

Historical Reaffirmation

Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)

$76.00

$76.00

$136.80


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs in nominal thread diameters M6 to M36 inclusive manufactured from a number of alloys in common use and intended for general service applications.

1.2 Unless otherwise specified, nuts used on these bolts, cap screws, and studs shall conform to the requirements of Specification F467M. Nuts shall be of the same alloy group as the fastener on which they are used and shall have a specified minimum proof stress equal to or greater than the specified minimum tensile strength stress of the fastener on which they are used.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

Note 1: This specification is the metric companion of Specification F468.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs manufactured from a number of alloys in common use and intended for general service applications. The bolts, cap screws, and studs shall be manufactured from material having a chemical composition conforming to the requirements specified. The fasteners shall be cold formed, hot formed, or machined from suitable material. Different tests shall be conducted in order to determine the following mechanical properties of fasteners: hardness, tensile strength, yield strength, and elongation.


13.1 For purposes of determining compliance with the specified limits for requirements of the properties listed in this specification, an observed value or calculated value shall be rounded in accordance with Practice E29.

SDO ASTM: ASTM International
Document Number F468
Publication Date Sept. 1, 2018
Language en - English
Page Count 11
Revision Level 06(2018)
Supercedes
Committee F16.04
Publish Date Document Id Type View
May 1, 2006 F0468M-06E01 Revision
May 1, 2006 F0468M-06 Revision
Nov. 1, 2005 F0468M-05A Revision
Oct. 1, 2005 F0468M-05 Revision
Oct. 1, 2003 F0468M-03A Revision
May 10, 2003 F0468M-03 Revision
Oct. 10, 2001 F0468M-98 Revision
Oct. 10, 2001 F0468M-01A Revision
Oct. 10, 2001 F0468M-01 Revision
Sept. 1, 2018 F0468M-06R18 Reaffirmation
April 1, 2012 F0468M-06R12 Reaffirmation