Logo

ASTM F468-23

Current Revision

Standard Specification for Nonferrous Bolts, Hex Cap Screws, Socket Head Cap Screws, and Studs for General Use

$76.00

$76.00

$136.80

$91.00

$91.00

$163.80



Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

Document Preview Not Available...

1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs 0.250 to 1.500 in., socket head cap screws (including socket head cap, button head and flat countersunk head configurations) with nominal thread 0.06 (size 0) through 1.500 in. and low head socket cap screws with nominal thread 0.112 (size 4) through 0.625 (5/8 ) in. inclusive in diameter manufactured from a number of alloys in common use and intended for general service applications.

1.2 Applicable nuts for use with bolts, cap screws, and studs covered by this specification are covered by Specification F467.

1.2.1 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

Note 1: A complete metric companion to Specification F468 has been developed—F468M; therefore no metric equivalents are presented in this specification.

1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs manufactured from a number of alloys in common use and intended for general service applications. The bolts, cap screws, and studs shall be manufactured from material having a chemical composition conforming to the requirements specified. The fasteners shall be cold formed, hot formed, or machined from suitable material. Different tests shall be conducted in order to determine the following mechanical properties of fasteners: hardness, tensile strength, yield strength, and elongation.


12.1 For purposes of determining compliance with the specified limits for requirements of the properties listed in this specification, an observed value or calculated value shall be rounded in accordance with Practice E29.

SDO ASTM: ASTM International
Document Number F468
Publication Date June 1, 2023
Language en - English
Page Count 15
Revision Level 23
Supercedes
Committee F16.04
Publish Date Document Id Type View
June 1, 2023 F0468-23 Revision
Nov. 1, 2022 F0468-22 Revision
Aug. 1, 2016 F0468-16 Revision
Dec. 1, 2015 F0468-15E01 Revision
Dec. 1, 2015 F0468-15 Revision
Nov. 1, 2013 F0468-13 Revision
June 1, 2012 F0468-12 Revision
June 1, 2010 F0468-10 Revision
May 1, 2006 F0468-06E01 Revision
May 1, 2006 F0468-06 Revision
Nov. 1, 2005 F0468-05A Revision
Oct. 1, 2005 F0468-05 Revision
Oct. 1, 2003 F0468-03A Revision
May 10, 2003 F0468-03 Revision
Oct. 10, 2001 F0468-98 Revision
Oct. 10, 2001 F0468-01E01 Revision
Oct. 10, 2001 F0468-01A Revision
Oct. 10, 2001 F0468-01 Revision