Logo

ASTM F37-06

Current Revision

Standard Test Methods for Sealability of Gasket Materials

$83.00

$83.00

$149.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 These test methods provide a means of evaluating the sealing properties of sheet and solid form-in-place gasket materials at room temperature. Test Method A is restricted to liquid leakage measurements, whereas Test Method B may be used for both liquid and gas leakage measurements.

1.2 These test methods are suitable for evaluating the sealing characteristics of a gasket material under different compressive flange loads. The test method may be used as an acceptance test when the producer and user have agreed to specific test conditions for the following parameters: test medium, internal pressure on medium, and flange load on gasket specimens.

1.3 These test methods use a small-diameter narrow-width gasket as the test specimen under relatively low gasket loads and relatively low pressures. Test Method F 2378 is another sealability test method that uses a larger gasket specimen and higher internal pressures and flange loads.

1.4 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (For specific hazard or warning statements, or both, see 5.2.11, Section 6, 6.3, 8.2.4, 11.3.2, and 11.4.2.)


These test methods are designed to compare gasket materials under controlled conditions and to provide a precise measure of leakage rate.

These test methods are suitable for measuring leakage rates as high as 6 L/h and as low as 0.3 mL/h. In many cases, zero leakage may not be attainable.

These test methods evaluate leakage rates after time periods that are typically 5 to 30 min under load. Holding a gasket material under load for extended time periods may give different results.

If the fluid being used in the test causes changes, such as swelling, in the gasket material, then unpredictable results may be obtained.

SDO ASTM: ASTM International
Document Number F37
Publication Date Nov. 15, 2006
Language en - English
Page Count 8
Revision Level 06
Supercedes
Committee F03.10
Publish Date Document Id Type View
Nov. 15, 2006 F0037-06 Revision
April 10, 2000 F0037-00 Revision
Sept. 1, 2024 F0037-06R24 Reaffirmation
May 1, 2019 F0037-06R19 Reaffirmation
May 1, 2013 F0037-06R13 Reaffirmation