Logo

ASTM F2764/F2764M-19

Historical Revision

Standard Specification for 6 in. to 60 in. [150 mm to 1500 mm] Polypropylene (PP) Corrugated Double and Triple Wall Pipe and Fittings for Non-Pressure Sanitary Sewer Applications

$83.00

$83.00

$149.40

$0.00

$0.00

$0.00



Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This specification covers requirements and test methods for corrugated double and triple wall polypropylene pipe and fittings. The nominal inside diameters covered are 6 to 60 in. [150 to 1500 mm].

1.2 The requirements of this specification are intended to provide pipe and fittings for underground use for non-pressure sanitary sewer systems. Pipe and fittings produced in accordance with this specification shall be installed in compliance with Practice D2321.

1.3 This specification covers pipe and fittings with an annular corrugated wall and an essentially smooth interior wall (that is, double wall) (Fig. 1) and pipe and fittings with an annular corrugated wall and an essentially smooth interior and exterior wall (that is, triple wall) (Fig. 2).

FIG. 1 Typical Corrugated Double Wall Pipe

Typical Corrugated Double Wall PipeTypical Corrugated Double Wall Pipe

FIG. 2 Typical Corrugated Triple Wall Pipe

Typical Corrugated Triple Wall PipeTypical Corrugated Triple Wall Pipe

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 The following precautionary statement applies only to Section 7 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


SDO ASTM: ASTM International
Document Number F2764
Publication Date April 1, 2019
Language en - English
Page Count 9
Revision Level 19
Supercedes
Committee F17.62
Publish Date Document Id Type View
July 1, 2024 F2764_F2764M-24 Revision
Feb. 1, 2023 F2764_F2764M-23 Revision
April 1, 2019 F2764_F2764M-19 Revision
Nov. 1, 2018 F2764_F2764M-18A Revision
Oct. 1, 2018 F2764_F2764M-18 Revision
April 1, 2017 F2764_F2764M-17E01 Revision
April 1, 2017 F2764_F2764M-17 Revision
Aug. 1, 2016 F2764_F2764M-16 Revision
May 1, 2011 F2764_F2764M-11AE02 Revision
May 1, 2011 F2764_F2764M-11AE01 Revision