Logo

ASTM F1316-18(2023)

Historical Reaffirmation

Standard Test Method for Measuring the Transmissivity of Transparent Parts

$69.00

$69.00

$124.20


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This test method describes an apparatus and procedure that is suitable for measuring the transmissivity of large, thick, or curved transparent parts including parts already installed. This test method is limited to transparencies that are relatively neutral with respect to wavelength (not highly colored).

1.2 Since the transmissivity (transmission coefficient) is a ratio of two luminance values, it has no units. The units of luminance recorded in the intermediate steps of this test method are not critical; any recognized units of luminance (for example, foot-lamberts or candelas per square metre) are acceptable for use, as long as use is consistent.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


5.1 Significance—This test method provides a means to measure the transmissivity of parts in the field (already installed on aircraft) and of large, thick or curved parts physically difficult to measure using Test Method D1003.

5.2 Use—This test method is acceptable for use on any transparent part. It is primarily intended for use on large, curved, or thick parts either pre- or post-installation (for example, windscreens on aircraft).

SDO ASTM: ASTM International
Document Number F1316
Publication Date May 1, 2023
Language en - English
Page Count 5
Revision Level 18(2023)
Supercedes
Committee F07.08
Publish Date Document Id Type View
June 1, 2018 F1316-18 Revision
Nov. 15, 1990 F1316-90R02 Revision
May 1, 2023 F1316-18R23 Reaffirmation
Dec. 1, 2013 F1316-90R13 Reaffirmation
April 1, 2008 F1316-90R08 Reaffirmation
Nov. 15, 1990 F1316-90R96 Reaffirmation