Logo

ASTM F1303-04

Current Revision

Standard Specification for Sheet Vinyl Floor Covering with Backing

$73.00

$73.00

$131.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This specification covers floor covering having a vinyl plastic wear layer with backing. Products may also contain non-PVC specialty performance top layer(s) or intermediate layer(s), or both.

1.2 Two types of floor covering based on binder content are covered. The floor covering is intended for use in commercial, light commercial, and residential buildings based on serviceability characteristics. General information and performance characteristics that determine serviceability and recommended use are included in this specification.

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 The following safety hazards caveat pertains only to the test methods portion, Section 11, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


This specification covers resilient floor covering having a vinyl plastic wear layer with backing intended for use in commercial, light commercial, and residential building applications. Material covered by this specification consists of Types I and II floor covering, which may further be classified according to grade (Grades 1, 2, and 3) and backing classes (Class A, B, and C). the floor covering shall consist of a vinyl plastic wear layer (transparent, translucent, or opaque, with the surface smooth, embossed, or textured with or without valley printing), intermediate layers made of foam and reinforcing materials, and backing (which may be fibrous, nonfoamed plastic, or foamed plastic). Tests for wear layer binder content, wear layer thickness, overall thickness, residual indentation, flexibility, and resistance to chemicals, heat, light, and static load shall be performed and shall conform to the requirements specified.


SDO ASTM: ASTM International
Document Number F1303
Publication Date March 1, 2004
Language en - English
Page Count 4
Revision Level 04
Supercedes
Committee F06.80
Publish Date Document Id Type View
March 1, 2004 F1303-04 Revision
Sept. 10, 2002 F1303-02 Revision
March 10, 1999 F1303-99 Revision
June 1, 2021 F1303-04R21 Reaffirmation
May 1, 2014 F1303-04R14 Reaffirmation
Dec. 1, 2009 F1303-04R09 Reaffirmation