Logo

ASTM F1201-88(2021)

Current Reaffirmation

Standard Specification for Fluid Conditioner Fittings in Piping Applications Above 0&#176F

$61.00

$61.00

$109.80


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


...

1.1 This specification provides the minimum requirements for pressure-retaining components of fluid conditioner fittings. It addresses the pressure-retaining component design, fabrication, rating, marking, and testing.

1.2 This specification is not intended to override any of the present fluid conditioner fitting specifications specific to devices such as strainers, filters, and traps but should be used for devices for which a specific specification does not apply.

1.3 This specification provides sufficient requirements to allow a fluid conditioner fitting to be used in the marine environment.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 The following precautionary caveat pertains only to the test methods portion, Section 7, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


This specification provides the minimum requirements for pressure-retaining components of fluid conditioner fittings. It addresses the pressure-retaining component design, fabrication, rating, marking, and testing. Classification: Class I-fluid conditioner fitting meeting the requirements specified, and Class II - all other fluid conditioner fittings. All fluid conditioner fittings shall be pressure tested to meet the requirements prescribed.


SDO ASTM: ASTM International
Document Number F1201
Publication Date Jan. 1, 2021
Language en - English
Page Count 4
Revision Level 88(2021)
Supercedes
Committee F25.11
Publish Date Document Id Type View
Jan. 1, 2021 F1201-88R21 Reaffirmation
Sept. 1, 2016 F1201-88R16 Reaffirmation
May 1, 2010 F1201-88R10 Reaffirmation
Nov. 1, 2004 F1201-88R04 Reaffirmation
April 10, 1998 F1201-88R98 Reaffirmation