Logo

ASTM F1110-09(2020)

Historical Reaffirmation

Standard Test Method for Sandwich Corrosion Test

$69.00

$69.00

$124.20


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This test method defines the procedure for evaluating the corrosivity of aircraft maintenance chemicals, when present between faying surfaces (sandwich) of aluminum alloys commonly used for aircraft structures. This test method is intended to be used in the qualification and approval of compounds employed in aircraft maintenance operations.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information.

1.3 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements appear in Section 9.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


5.1 The data generated by this test method shall be used to determine whether aircraft structural aluminum alloys are liable to be corroded or damaged by application of the test material during routine maintenance operations.

5.2 Interpretation of the sandwich corrosion test results is based on a comparison of the appearance of faying surfaces of three sets of coupons. One set of test coupons is exposed with reagent water only in the faying surfaces, to establish the baseline (controls) against which the panels exposed to the test material are compared. Disregard corrosion at cut edges of the test coupons.

5.3 The relative corrosion severity rating system is provided in order to allow a numerical classification of the test results and to eliminate the necessity for elaborate weight loss measurements. Pitting corrosion, which is rated 4—extensive (severe) corrosion, may involve only a negligible weight loss.

5.4 Relative corrosion severity rating system:

Appearance/Corrosion:

0—No visible corrosion and no discoloration present

1—Very slight corrosion or very slight discoloration, and/or up to 5 % of areaA corroded

2—Discoloration and/or up to 10 % of areaA corroded

3—Discoloration and/or up to 25 % of areaA corroded

4—Discoloration and/or more than 25 % of areaA corroded, and/or pitting
  present

(A) ”Area” refers to area under the filter paper, or if no filter paper is used, the area where the test material was applied.

SDO ASTM: ASTM International
Document Number F1110
Publication Date Nov. 1, 2020
Language en - English
Page Count 5
Revision Level 09(2020)
Supercedes
Committee F07.07
Publish Date Document Id Type View
May 15, 2009 F1110-09 Revision
May 1, 2008 F1110-08 Revision
Aug. 10, 2002 F1110-02 Revision
Nov. 1, 2020 F1110-09R20 Reaffirmation
Dec. 1, 2014 F1110-09R14 Reaffirmation
Jan. 1, 1990 F1110-90R98 Reaffirmation