Logo

ASTM F1006-86(2022)

Current Reaffirmation

Standard Specification for Entrainment Separators for Use in Marine Piping Applications

$61.00

$61.00

$109.80


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


...

1.1 This specification covers the minimum requirements for the pressure-temperature rating, testing, and making of pressure-containing vessels for entrainment separators.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 The following safety hazards caveat pertains only to the test methods portion, Section 6, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


This specification covers the minimum requirements for the pressure-temperature rating, testing, and making of pressure-containing vessels for entrainment separators. Entrainment separators covered in this specification shall be designed according to the lowest pressure-temperature rating of any individual component, or as established by proof tests. Test water temperature and entrainment separator temperature must be at equilibrium before hydrostatic test pressure is applied. All possible air pockets must be purged while the entrainment separator vessel is being filled with water. External equipment not to be pressurized with the entrainment separator should be isolated or disconnected before applying the hydrostatic test pressure. Hydrostatic test pressure shall be applied gradually to the entrainment separator and held stationary at each increment for a sufficient time in order that a visual inspection can be made for leaks or deformation of the vessel.


SDO ASTM: ASTM International
Document Number F1006
Publication Date Oct. 1, 2022
Language en - English
Page Count 3
Revision Level 86(2022)
Supercedes
Committee F25.11
Publish Date Document Id Type View
Nov. 1, 2008 F1006-86R14E01 Revision
Not Available F1006-86R92 Revision
Oct. 1, 2022 F1006-86R22 Reaffirmation
Sept. 1, 2018 F1006-86R18 Reaffirmation
Nov. 1, 2008 F1006-86R08 Reaffirmation
May 1, 2004 F1006-86R04 Reaffirmation
Jan. 1, 1997 F1006-86R97 Reaffirmation