Logo

ASTM E1399-97(2000)

Historical Reaffirmation

Standard Test Method for Cyclic Movement and Measuring the Minimum and Maximum Joint Widths of Architectural Joint Systems

$83.00

$83.00

$149.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


...

1.1 This test method covers testing procedures for architectural joint systems. This test method is intended for the following uses:

1.1.1 To verify movement capability information supplied to the user by the producer,

1.1.2 To standardize comparison of movement capability by relating it to specified nominal joint widths.

1.1.3 To determine the cyclic movement capability between specified minimum and maximum joint widths without visual deleterious effects, and

1.1.4 To provide the user with graphic information, drawings or pictures in the test report, depicting them at minimum, maximum, and nominal joint widths during cycling.

1.2 This test method is intended to be used only as part of a specification or acceptance criterion due to the limited movements tested.

1.3 The acceptable standard units of measure are SI units and the equivalent inch-pound units are expressed in parenthesis.

1.4 This standard does not purport to address the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


SDO ASTM: ASTM International
Document Number E1399
Publication Date Jan. 1, 2000
Language en - English
Page Count 5
Revision Level 97(2000)
Supercedes
Committee E06.21
Publish Date Document Id Type View
Nov. 1, 2009 E1399-97R09 Reaffirmation
May 1, 2005 E1399-97R05 Reaffirmation
Jan. 1, 2000 E1399-97R00 Reaffirmation