1.1 This specification covers compression molding thermosetting, urea-formaldehyde molding compounds as further defined in 3.1.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 The following safety hazards caveat pertains only to the test method portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
This specification covers the testing and requirements for two types of compression-molding, thermosetting urea-formaldehyde molding compounds. Type 1 are general purpose molding compounds with alpha-cellulose fillers, while, Type 2 are general purpose molding compounds with cellulose fillers other than alpha-cellulose. The molding compounds shall be of uniform composition, and the apparent density, bulk factor, plasticity, particle size, and color shall be compounded as to conform to the requirements prescribed herein. Also, sampled test specimens shall be examined and conform correspondingly to the following physical requirements: specific gravity; flexural strength; impact resistance; water absorption; dielectric strength; and arc resistance.
SDO | ASTM: ASTM International |
Document Number | D705 |
Publication Date | Dec. 1, 2012 |
Language | en - English |
Page Count | 2 |
Revision Level | 99(2012) |
Supercedes | |
Committee | D20.16 |