Logo

ASTM D705-99(2004)

Historical Reaffirmation

Standard Specification for Urea-Formaldehyde Molding Compounds

$73.00

$73.00

$131.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This specification covers compression molding thermosetting, urea-formaldehyde molding compounds as further defined in .

1.2 The values stated in SI units are to be regarded as the standard.

Note 1

The properties included in this specification are those required to identify the types of molding compounds covered. There may be other requirements necessary to identify particular characteristics. Transfer or injection molding will usually result in different physical and electrical characteristics than compression molding.

The following safety hazards caveat pertains only to the test method portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 2

ISO 2112-1977(E) is similar but not equivalent to this specification. Product classification and characterization are not the same.


This specification covers the testing and requirements for two types of compression-molding, thermosetting urea-formaldehyde molding compounds. Type 1 are general purpose molding compounds with alpha-cellulose fillers, while, Type 2 are general purpose molding compounds with cellulose fillers other than alpha-cellulose. The molding compounds shall be of uniform composition, and the apparent density, bulk factor, plasticity, particle size, and color shall be compounded as to conform to the requirements prescribed herein. Also, sampled test specimens shall be examined and conform correspondingly to the following physical requirements: specific gravity; flexural strength; impact resistance; water absorption; dielectric strength; and arc resistance.


SDO ASTM: ASTM International
Document Number D705
Publication Date Oct. 1, 2004
Language en - English
Page Count 2
Revision Level 99(2004)
Supercedes
Committee D20.16
Publish Date Document Id Type View
Nov. 10, 1999 D0705-99 Revision
Dec. 1, 2020 D0705-99R20 Reaffirmation
Dec. 1, 2012 D0705-99R12 Reaffirmation
Oct. 1, 2004 D0705-99R04 Reaffirmation