Logo

ASTM D7019-20

Current Revision

Standard Performance Specification for Brassiere, Slip, Lingerie and Underwear Fabrics

$61.00

$61.00

$109.80

$73.00

$73.00

$131.40



Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This performance specification covers fabrics used in brassieres underwear, slips, and lingerie.

1.2 These requirements apply to the length and width directions for those properties where each fabric direction is pertinent.

1.3 The following safety hazards caveat pertains only to the test methods described in this performance specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


This performance specification covers fabrics used in brassieres underwear, slips, and lingerie. The requirements apply to the length and width directions for those properties where each fabric direction is pertinent. The fabric shall conform to the required breaking strength, tearing strength, resistance to yarn slippage, bursting strength, dimensional change, colorfastness, appearance, and flammability.


4.1 Fabrics intended for this end-use should meet all of the requirements listed in Table 1.

(A) There is more than one method that can be used to measure breaking strength, tearing strength, bursting strength and lightfastness. These methods cannot be used interchangeably since there may be no overall correlation between them (see Note 2, Note 3, Note 4, and Note 6).
(B) See Note 5.

4.2 It should be recognized that fabric can be produced utilizing an almost infinite number of combinations of construction variables (e.g., type of fibers, percentage of fibers, yarn twist, yarn number, warp and pick count, chemical and mechanical finishes). Additionally, fashion or aesthetics dictate that the ultimate consumer may find acceptable articles made from fabrics that do not conform to all of the requirements in Table 1.

4.2.1 Hence, no single performance specification can possibly apply to all the various fabrics that could be utilized for this end-use.

4.3 The uses and significance of particular properties and test methods are discussed in the appropriate sections of the specified test methods.

SDO ASTM: ASTM International
Document Number D7019
Publication Date July 1, 2020
Language en - English
Page Count 3
Revision Level 20
Supercedes
Committee D13.61
Publish Date Document Id Type View
July 1, 2020 D7019-20 Revision
Feb. 1, 2014 D7019-14 Revision
July 1, 2005 D7019-05 Revision
June 1, 2010 D7019-05R10 Reaffirmation