Logo

ASTM D6989-03(2020)

Current Reaffirmation

Standard Practices for Preparation of Solvent and Water Based Ink Resin Solutions

$61.00

$61.00

$109.80


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


...

1.1 These practices describe laboratory procedures for preparing a solvent or water based ink resin solution in low boiling solvent or alkaline water using two types of lab equipment; (1) an industrial blender (Sections 3 – 7), and (2) a laboratory roller mill (Sections 8 – 12).

Note 1: ASTM Subcommittee D01.37 recommends using the industrial blender where possible.

1.2 These practices use laboratory equipment generally available in a normal, well-equipped laboratory.

1.3 These procedures are for use with ink resins intended mainly for liquid (for example, flexographic and rotogravure) inks. The type of resins is typically, but not limited to, acrylic and styrene/acrylic copolymers, polyamides, polyesters, polyvinylbutyral, and maleated/fumarated rosin esters.

1.4 The typical low boiling solvents to be used include ethanol, isopropanol, n-propanol, ethyl acetate, isopropyl acetate, and n-propyl acetate. For water based ink resin solutions, water is used in combination with ammonium hydroxide or amines such as dimethylethanolamine, monoethanolamine, and triethylamine.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


4.1 This practice provides a means of preparing resin solutions by the “cold cut” method, modeling high-shear production dispersion techniques.

SDO ASTM: ASTM International
Document Number D6989
Publication Date June 1, 2020
Language en - English
Page Count 3
Revision Level 03(2020)
Supercedes
Committee D01.37
Publish Date Document Id Type View
Dec. 1, 2003 D6989-03 Revision
June 1, 2020 D6989-03R20 Reaffirmation
June 1, 2013 D6989-03R13 Reaffirmation
June 1, 2008 D6989-03R08 Reaffirmation