Logo

ASTM D6932/D6932M-21

Current Revision

Standard Guide for Materials and Construction of Open-Graded Friction Course Plant Asphalt Mixtures

$61.00

$61.00

$109.80

$73.00

$73.00

$131.40



Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


...

1.1 This guide covers the construction of open-graded friction course (OGFC) plant asphalt mixtures. End-use specifications should be adopted to conform to job and user requirements. Where applicable, Specification D3666 should be applied as a minimum for agencies testing and inspecting road and paving materials.

1.2 Asphalt OGFCs are placed as the final wearing course for highways and airfields.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


4.1 This guide provides information to assist engineers with the design requirements and construction guidelines for paving an open-graded friction course (OGFC) surface layer. An OGFC is primarily used to improve the skid resistance and wear resistance of an asphalt pavement by providing an escape route for surface water beneath a moving wheel load. The asphalt mixture is typically produced with a low amount of fine aggregate particles and high air void content to provide a passageway of interconnected voids for moisture to drain away from the travelway. The film thickness of the asphalt and overall asphalt content are important for better stripping resistance and durability and aging properties.

Note 1: OGFCs may also be placed to reduce the tire-pavement interface noise and may also be placed to reduce the occurrence and severity of reflective cracking.

SDO ASTM: ASTM International
Document Number D6932
Publication Date May 1, 2021
Language en - English
Page Count 4
Revision Level 21
Supercedes
Committee D04.23
Publish Date Document Id Type View
May 1, 2021 D6932_D6932M-21 Revision
Aug. 1, 2008 D6932_D6932M-08 Revision
Dec. 1, 2013 D6932_D6932M-08R13 Reaffirmation