Logo

ASTM D6823-08(2021)

Historical Reaffirmation

Standard Specification for Commercial Boiler Fuels With Used Lubricating Oils

$83.00

$83.00

$149.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This specification covers four grades of fuel oil made of at least 25 % used lubricating oils. The four grades of fuel are intended for use in various types of fuel-oil-burning industrial equipment and commercial boilers under various climatic and operating conditions. These fuels are not intended for use in residential heaters.

1.1.1 Grades RFC4, RFC5L, RFC5H and RFC6 are used lubricating oil blends of increasing viscosity, with or without middle distillate or residual fuel oil, or both, that are intended for use in industrial burners and commercial boilers equipped to handle these types of fuels. This specification is for applications where Specification D6448 would not meet the performance or other requirements of the burner or boiler in question.

Note 1: For information on the significance of the terminology and test methods used in this specification, see Appendix X1.

1.2 This specification is for use in contracts for the purchase of fuel oils derived from used lubricating oil and for the guidance of consumers of such fuels. This specification does not address the frequency with which any particular test must be run.

1.3 Nothing in this specification shall preclude observance of national or local regulations which can be more restrictive. In some jurisdictions, used oil is considered a hazardous waste and fuels derived from used oil are required to meet certain criteria before use as a fuel.

Note 2: For United States federal requirements imposed on used oil generators, transporters and transfer facilities, reprocessors, marketers, and burners, see 40 CFR Part 279.

Note 3: The generation and dissipation of static electricity can create problems in the handling of distillate burner fuel oils. For more information on the subject, see Guide D4865.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4.1 Exception—Table 1 and Table X1.1 include inch-pound values in parentheses for information only.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


This specification covers four grades of fuel oil made of used lubricating oils. These four grades of fuel are proposed for use in various types of fuel-oil-burning industrial equipment and commercial boilers under various climatic and operating conditions. The four grades of fuel oil covered in this specification are RFC4, RFC5L, RFC5H, and RFC6. The fuel oils shall contain a minimum volume of used lubricating oil-derived products as prescribed herein. The oils shall also be homogeneous consisting primarily of hydrocarbons. The fuel oil shall not contain excessive amounts of organic or inorganic acids, or both, and shall be free of solid or fibrous matter.


SDO ASTM: ASTM International
Document Number D6823
Publication Date Nov. 1, 2021
Language en - English
Page Count 7
Revision Level 08(2021)
Supercedes
Committee D02.P0
Publish Date Document Id Type View
July 1, 2024 D6823-24 Revision
Oct. 1, 2008 D6823-08 Revision
Aug. 10, 2002 D6823-02 Revision
Nov. 1, 2021 D6823-08R21 Reaffirmation
July 1, 2013 D6823-08R13 Reaffirmation