Logo

ASTM D6754/D6754M-23

Current Revision

Standard Specification for Ketone Ethylene Ester Based Sheet Roofing

$61.00

$61.00

$109.80

$73.00

$73.00

$131.40



Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This specification covers flexible sheet made from ketone ethylene ester (KEE) as the primary polymer intended for use in single-ply roofing membrane exposed to the weather. The sheet shall be reinforced with fabric.

1.2 In-place roof system design criteria, such as fire resistance, field-seaming strength, material compatibility, uplift resistance, in-situ shrinkage, among others, are factors that must be considered but are beyond the scope of this specification.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.4 The following precautionary caveat pertains to the test methods portion only, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


This specification covers flexible sheet made from ketone ethylene ester (KEE) as the primary polymer intended for use in single ply roofing membrane exposed to the weather. The sheet shall be reinforced with fabric. The sheet shall be formulated from the appropriate polymers and other compounding ingredients. To make seam and repairs, the sheet shall be capable of being bonded watertight to itself during the design service life of the sheets. Overall thickness; thickness, coating over reinforcement optical method; breaking strength; elongation at break; tearing strength; linear dimensional change; fabric adhesion; heat aging; after heat aging low temperature bend; low temperature bend; water absorption; factory seam strength; hydrostatic resistance; static puncture test; accelerated weathering test; fungi resistance; abrasion test; and dimension tests shall be performed to conform with the requirements specified.


SDO ASTM: ASTM International
Document Number D6754
Publication Date Sept. 1, 2023
Language en - English
Page Count 3
Revision Level 23
Supercedes
Committee D08.18
Publish Date Document Id Type View
Sept. 1, 2023 D6754_D6754M-23 Revision
Nov. 1, 2015 D6754_D6754M-15 Revision
July 1, 2010 D6754_D6754M-10 Revision
June 15, 2022 D6754_D6754M-15R22 Reaffirmation