Logo

ASTM D6576-07

Historical Revision

Standard Specification for Flexible Cellular Rubber Chemically Blown

$83.00

$83.00

$149.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


...

1.1 This specification establishes requirements for chemically blown cellular rubber.

1.2 In the case of conflict between the provisions of this specification and those of detailed specifications or test methods for a particular product, the latter shall take precedence.

1.3 Unless specifically stated otherwise, by agreement between the purchaser and the supplier, all test methods shall be performed in accordance with the test methods specified in this specification.

1.4 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.5 There is no known ISO equivalent to this specification.

Note 1

This specification was revised using the updated test methods and specifications in Specification D 1056 - 07.


This specification establishes requirements for chemically blown cellular rubber. Cellular rubber may be classified into two types: Type I which is open cell or sponge rubber and Type II which is closed cell or expanded rubber. Both types are divided into three grades: Grade A which is oil-and flame-resistant, Grade B which has no requirements for oil ,flame resistance, or low temperature, and Grade C which is low-temperature resistant. Each type and class has been divided into three different conditions. Each condition is based on a specific range of firmness as expressed by compression deflection as follows: super soft, soft, soft-medium, medium, medium-firm, and firm conditions. Several tests shall be performed in order to determine the following physical properties of cellular rubber: compression deflection, low-temperature resistance, accelerated aging, recovery, flame resistance, shrinkage, water absorption, oil aging, and color.


SDO ASTM: ASTM International
Document Number D6576
Publication Date Sept. 1, 2007
Language en - English
Page Count 8
Revision Level 07
Supercedes
Committee D20.22
Publish Date Document Id Type View
July 1, 2020 D6576-20 Revision
Nov. 15, 2013 D6576-13 Revision
Sept. 1, 2007 D6576-07 Revision
July 10, 2000 D6576-00 Revision