Logo

ASTM D6221/D6221M-00(2021)

Current Reaffirmation

Standard Specification for Reinforced Bituminous Flashing Sheets for Roofing and Waterproofing

$61.00

$61.00

$109.80


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


...

1.1 This specification covers factory-prepared reinforced bituminous sheet used in flashing. The bitumen used may be asphalt, coal-tar pitch, or polymer-modified bitumen. The reinforcement may include any one or a combination of organic (wood fiber), polyester, or glass fiber felts, woven fabrics, or thermoplastic films. Fine mineral powders, granules, or metal foils may be used as surfacing.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.3 The following precautionary statement pertains only to the test method portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


This specification covers two types of factory prepared reinforced bituminous flashing sheets used for roofing and waterproofing systems. The bitumen used may be asphalt, coal-tar pitch, or polymer modified bitumen. The reinforcement may include any one or a combination of organic (wood fiber), polyester, or glass fiber felts, woven fabrics, or thermoplastic films. Fine mineral powders, granules, or metal foils may be used as surfacing. Specimens shall be sampled, be tested for, and consequently conform to dimensional and physical properties, as follows: mass; thickness; load-strain properties; impact resistance; tear strength and resistance; flexibility; breaking load; and elongation at break. Calculation procedures for the mean, estimated standard deviation, and mean variance of test values from specimens tested before and after heat conditioning are also detailed.


SDO ASTM: ASTM International
Document Number D6221
Publication Date Nov. 15, 2021
Language en - English
Page Count 3
Revision Level 00(2021)
Supercedes
Committee D08.04
Publish Date Document Id Type View
Nov. 15, 2021 D6221_D6221M-00R21 Reaffirmation
May 1, 2014 D6221_D6221M-00R14E01 Reaffirmation