Logo

ASTM D6037-13

Historical Revision

Standard Test Methods for Dry Abrasion Mar Resistance of High Gloss Coatings

$83.00

$83.00

$149.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This test method covers procedures for evaluating the relative mar resistance of high gloss coatings. Two test methods are included. Test Method A uses a device that contains a rotating specimen holder and two abrasive wheels. Test Method B uses a device that contains a reciprocating specimen holder and a single wheel that has been fitted with abrasive paper. Either method can be used to evaluate the dry abrasion mar resistance of coatings applied to planar, rigid surfaces. Each test method provides good discrimination between highly mar resistant coatings.

Note 1The mar resistance values obtained by these test methods have no absolute significance. They should only be used to derive relative performance rankings for test panels that have been prepared from the series of coatings that are currently being evaluated. If mar resistance values are quoted between laboratories, it is essential that a common standard be measured and that the values be compared to that standard. Even then, the values should be used with caution.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


5.1 Coatings, particularly the high gloss coatings used on automobiles, boats, toys, etc., are subject to a wide variety of conditions (for example, wiping, cleaning, and exposure) that can mar their surface. The ability of these coatings to maintain their appearance is an important product attribute. These test methods provide a way to estimate the ability of high gloss coatings to resist mar damage.

5.2 These test methods do not provide fundamental values. However they are suitable for estimating the ability of high gloss coatings to resist mar.

5.3 Since the susceptibility of coatings to marring varies widely, the number of cycles that are needed to cause “relevant” mar damage also varies. Usually, 2 to 50 cycles are sufficient.

SDO ASTM: ASTM International
Document Number D6037
Publication Date June 1, 2013
Language en - English
Page Count 7
Revision Level 13
Supercedes
Committee D01.23
Publish Date Document Id Type View
June 1, 2021 D6037-21 Revision
Nov. 1, 2018 D6037-18 Revision
June 1, 2013 D6037-13E01 Revision
June 1, 2013 D6037-13 Revision
Jan. 1, 1996 D6037-96 Revision
July 1, 2008 D6037-96R08 Reaffirmation
Nov. 10, 1996 D6037-96R02 Reaffirmation