Logo

ASTM D5141-09

Historical Revision

Standard Test Method for Determining Filtering Efficiency and Flow Rate of the Filtration Component of a Sediment Retention Device

$83.00

$83.00

$149.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


...

1.1 This test method is used to determine the filtering efficiency and the flow rate of the filtration component of a sediment retention device, such as a silt fence, silt barrier, or inlet protector.

1.1.1 The results are shown as a percentage for filtering efficiency and cubic metres per square metre per minute (m3/m2/min) or gallons per square foot per minute (gal/ft2/min) for flow rate.

1.1.2 The filtering efficiency indicates the percent of sediment removed from sediment-laden water.

1.1.3 The flow rate is the average rate of passage of the sediment-laden water through the filtration component of a sediment retention device.

1.2 This test method requires several specialized pieces of equipment, such as an integrated water sampler and an analytical balance, and site specific soil from the construction project.

1.3 The values stated in SI units are the standard, while the inch-pound units are provided for information. The values expressed in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

This test method is used to determine the filtering efficiency and flow rate of the filtration component of a sediment retention device, such as a silt fence, a silt barrier, or a silt curtain, for specific soil conditions.

This test method may be used for the design of the filtration component of a sediment retention device to meet requirements of regulatory agencies in filtering efficiency or flow rate for specific soil conditions.

The designer can use this test method to determine the spacing between sediment retention devices.

This test method is intended for performance evaluation, as the results will depend on the specific soil evaluated. It is recommended that the user or representative perform the test to pre-approved products, as sediment retention device manufacturers are not typically equipped to handle or test soil requirements.

This test method provides a means of evaluating the filtration component of sediment retention devices with different soils under various conditions that simulate the conditions that exist in a sediment retention device installation. This test method may be used to simulate several storm events on the same sediment retention device specimen. Therefore, the number of times this test is repeated per specimen is dependent upon the user and the site conditions.

SDO ASTM: ASTM International
Document Number D5141
Publication Date Jan. 15, 2009
Language en - English
Page Count 5
Revision Level 09
Supercedes
Committee D35.03
Publish Date Document Id Type View
Sept. 1, 2023 D5141-23 Revision
Oct. 1, 2011 D5141-11 Revision
Jan. 15, 2009 D5141-09 Revision
Feb. 1, 2018 D5141-11R18 Reaffirmation
June 10, 1999 D5141-96R99 Reaffirmation
May 10, 1996 D5141-96R04 Reaffirmation