Logo

ASTM D4975-04(2011)

Historical Reaffirmation

Standard Test Methods for Single-Filament Tire Bead Wire Made from Steel (Withdrawn 2023)

$83.00

$83.00

$149.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 These test methods cover testing of single-filament steel wires that are components of tire beads used in the manufacture of pneumatic tires. By agreement, these test methods may be applied to similar filaments used for reinforcing other rubber products.

1.2 These test methods describe test procedures only and do not establish specifications and tolerances.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.


The procedures for the determination of properties of single-filament bead wire made from steel are considered satisfactory for acceptance testing of commercial shipments of this product because the procedures are the best available and have been used extensively in the trade.

In case of a dispute arising from differences in reported test results when using these test methods for acceptance testing of commercial shipments, the purchaser and supplier should conduct comparative test to determine if there is a statistical bias between their laboratories. Competent statistical assistance is recommended for the investigation of bias. As a minimum, the two parties should take a group of test specimens which are as homogeneous as possible and which are from a lot of material of the type in question. The test specimens then should be randomly assigned in equal number to each laboratory for testing. The average results from the two laboratories should be compared using Student's t-test for unpaired data and an acceptable probability level chosen by the two parties before testing is begun. If a bias is found, either its cause must be determined and corrected or the purchaser and the supplier must agree to interpret future test results with consideration to the known bias.

SDO ASTM: ASTM International
Document Number D4975
Publication Date Jan. 1, 2011
Language en - English
Page Count 6
Revision Level 04(2011)
Supercedes
Committee D13.19
Publish Date Document Id Type View
May 15, 2014 D4975-14 Revision
Oct. 1, 2004 D4975-04 Revision
Sept. 10, 2002 D4975-02A Revision
April 10, 2002 D4975-02 Revision
Jan. 1, 1996 D4975-96A Revision
Jan. 1, 2011 D4975-04R11 Reaffirmation
Jan. 1, 2010 D4975-04R10 Reaffirmation