Logo

ASTM D471-06

Historical Revision

Standard Test Method for Rubber Property—Effect of Liquids

$91.00

$91.00

$163.80


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This test method covers the required procedures to evaluate the comparative ability of rubber and rubber-like compositions to withstand the effect of liquids. It is designed for testing: ( 1) specimens of vulcanized rubber cut from standard sheets (see Practice D 3182), (2) specimens cut from fabric coated with vulcanized rubber (see Test Methods D 751), or (3) finished articles of commerce (see Practice D 3183). This test method is not applicable to the testing of cellular rubbers, porous compositions, and compressed sheet packing, except as described in 11.2.2.

1.2 ASTM Oils No. 2 and No. 3, formerly used in this test method as standard test liquids, are no longer commercially available and in 1993 were replaced with IRM 902 and IRM 903, respectively (see Appendix X1 for details).

1.3 ASTM No. 1 Oil, previously used in this test method as a standard test liquid, is no longer commercially available and in 2005 was replaced with IRM 901; refer to , Footnote A, and Appendix X3 for details.

1.4 This test method includes the following:

1.5 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


Certain rubber articles, for example, seals, gaskets, hoses, diaphragms, and sleeves, may be exposed to oils, greases, fuels, and other fluids during service. The exposure may be continuous or intermittent and may occur over wide temperature ranges.

Properties of rubber articles deteriorate during exposure to these liquids, affecting the performance of the rubber part, which can result in partial failure.

This test method attempts to simulate service conditions through controlled accelerated testing, but may not give any direct correlation with actual part performance, since service conditions vary too widely. It yields comparative data on which to base judgment as to expected service quality.

This test method is suitable for specification compliance testing, quality control, referee purposes, and research and development work.

SDO ASTM: ASTM International
Document Number D471
Publication Date Oct. 1, 2006
Language en - English
Page Count 13
Revision Level 06
Supercedes
Committee D11.15
Publish Date Document Id Type View
July 1, 2016 D0471-16A Revision
Feb. 1, 2016 D0471-16 Revision
Nov. 1, 2015 D0471-15A Revision
July 1, 2015 D0471-15 Revision
Dec. 1, 2012 D0471-12A Revision
May 1, 2012 D0471-12 Revision
Oct. 1, 2010 D0471-10 Revision
Oct. 1, 2006 D0471-06E01 Revision
Oct. 1, 2006 D0471-06 Revision
Sept. 28, 1999 D0471-98E01 Revision
Nov. 10, 1998 D0471-98E02 Revision
Not Available D0471-96 Revision
May 1, 2021 D0471-16AR21 Reaffirmation