Logo

ASTM D375-95(2004)e1

Current Revision

Standard Specification for Asbestos Roving

$73.00

$73.00

$131.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This specification covers asbestos roving having a minimum of 75 mass % asbestos fiber, excluding the mass of other inorganic reinforcing strands which may be present.

1.2 Warning-Breathing of asbestos dust is hazardous. Asbestos and asbestos products present demonstrated health risks for users and for those with whom they come into contact. In addition to other precautions, when working with asbestos-cement products, minimize the dust that results. For information on the safe use of chrysoltile asbestos, refer to "Safe Use of Chrysotile Asbestos: A Manual on Preventive and Control Measures."

1.3 The following safety hazards caveat pertains only to the test methods, Section 13, described in this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific safety hazard warning, see 1.2.

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.


This specification covers asbestos roving have a specified minimum of mass % asbestos fiber, excluding the mass of other inorganic reinforcing strands which may be present. Asbestos roving covered here are classified into classes (Classes A, B, C, D, and E) according to structural component, grades (Commercial, Underwriters', A, AA, AAA, and AAAA) according to percentage of asbestos content by mass, and electrical insulation type (Types II, IV, and VI) according to magnetic rating. Specimens shall be sampled, prepared, tested, and conform accordingly to specified chemical composition (reinforcement and asbestos content), electromagnetic (electrical insulation), mechanical (tensile or breaking strength), and dimensional (roving number or linear density) property requirements.


SDO ASTM: ASTM International
Document Number D375
Publication Date June 1, 2004
Language en - English
Page Count 4
Revision Level 95(2004)e1
Supercedes
Committee C17.03
Publish Date Document Id Type View
June 1, 2004 D0375-95R04E01 Revision
June 1, 2004 D0375-95R04 Reaffirmation
May 10, 1999 D0375-95R99 Reaffirmation