Logo

ASTM D2724-19

Current Revision

Standard Test Method for Bond Strength of Bonded, Fused, and Laminated Apparel Fabrics

$69.00

$69.00

$124.20

$83.00

$83.00

$149.40



Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This test method covers procedures for characterizing the bond strength of bonded, fused, and laminated apparel fabrics before or after drycleaning and laundering.

1.2 The values stated in SI units are to be regarded as standard; the values in parentheses are provided as information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. See 6.1.1 for a specific warning.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


5.1 This test method for the determination of bond strength of bonded, fused, or laminated apparel fabrics, is considered satisfactory for acceptance testing of commercial shipments of bonded and laminated apparel fabrics.

5.1.1 If there are differences of practical significance between reported test results for two laboratories (or more), comparative tests should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, use the samples for such a comparative test that are as homogeneous as possible, drawn from the same lot of material as the samples that resulted in disparate results during initial testing. Randomly assign specimens in equal numbers to each laboratory. The test results from the laboratories involved should be compared using a statistical test for unpaired data and a probability level chosen prior to the testing series. If bias is found, either its cause must be found and corrected, or future test results for that material must be adjusted in consideration of the known bias.

SDO ASTM: ASTM International
Document Number D2724
Publication Date Jan. 1, 2019
Language en - English
Page Count 5
Revision Level 19
Supercedes
Committee D13.59
Publish Date Document Id Type View
Jan. 1, 2019 D2724-19 Revision
July 1, 2007 D2724-07 Revision
Oct. 1, 2003 D2724-03 Revision
July 1, 2015 D2724-07R15 Reaffirmation
May 1, 2011 D2724-07R11E01 Reaffirmation
May 1, 2011 D2724-07R11 Reaffirmation
July 31, 1987 D2724-87R03 Reaffirmation
Jan. 1, 1987 D2724-87R95 Reaffirmation