Logo

ASTM D2671-00(2007)e1

Current Reaffirmation

Standard Test Methods for Heat-Shrinkable Tubing for Electrical Use

$91.00

$91.00

$163.80


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Document Preview Not Available...

1.1 These test methods cover the testing of heat-shrinkable tubing used for electrical insulation. Materials used include poly(vinyl chloride), polyolefins, fluorocarbon polymers, silicone rubber, and other plastic or elastomeric compounds.

1.2 The values stated in inch-pound units are the standard except for temperature, which shall be expressed in degrees Celsius. Values stated in parentheses are for information only.

1.3 The procedures appear in the following sections:

1.4 This is a fire-test-response standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Sections and .

Note 1

These test methods are similar, but not identical to, those in IEC 60684-2 (see also Note 0).

1.5 This is a fire-test-response standard. The test procedures measure the resistance of the tubing to ignition and propagation of flame after ignition under prescribed conditions of test.

1.6 This standard is used to measure and describe the response of materials, products, or assemblies to heat and flame under controlled conditions, but does not by itself incorporate all factors required for fire hazard or fire risk assessment of the materials, products, or assemblies under actual fire conditions.


These test methods include most of the important tests used to characterize heat-shrinkable tubing. They are intended primarily for, but not limited to, extruded heat-shrinkable tubing.

Variations in these test methods or alternate contemporary methods of measurement may be used to determine the values for the properties in this standard provided such methods ensure quality levels and measurement accuracy equal to or better than those prescribed herein. It is the responsibility of the organizations using alternate test methods to be able to demonstrate this condition. In cases of dispute, the methods specified herein shall be used.

Note 2—Provision for alternate methods is necessary because of (1) the desire to simplify procedures for specific applications without altering the result, and (2) the desire to eliminate redundant testing and use data generated during manufacturing process control, including that generated under Statistical Process Control (SPC) conditions, using equipment and methods other than those specified herein. An example would be the use of laser micrometers or optical comparators to measure dimensions.

SDO ASTM: ASTM International
Document Number D2671
Publication Date Feb. 15, 2007
Language en - English
Page Count 18
Revision Level 00(2007)e1
Supercedes
Committee D09.07
Publish Date Document Id Type View
Jan. 1, 2021 D2671-21 Revision
Nov. 1, 2013 D2671-13 Revision
Oct. 1, 2009 D2671-09 Revision
April 10, 2000 D2671-00 Revision
Feb. 15, 2007 D2671-00R07E01 Reaffirmation