Logo

ASTM D2162-21

Current Revision

Standard Practice for Basic Calibration of Master Viscometers and Viscosity Oil Standards

$69.00

$69.00

$124.20

$83.00

$83.00

$149.40



Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


...

1.1 This practice covers the calibration of master viscometers and viscosity oil standards, both of which may be used to calibrate routine viscometers as described in Test Method D445 and Specifications D446 over the temperature range from 15 °C to 100 °C.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.2.1 The SI-based units for calibration constants and kinematic viscosities are mm2/s2 and mm 2/s, respectively.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see Section 7.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


5.1 Because there are surface tension or kinematic viscosity differences, or both, between the primary standard (7.4) and kinematic viscosity standards (7.5), special procedures using master viscometers are required to “step-up” from the kinematic viscosity of the primary standard to the kinematic viscosities of oil standards.

5.2 Using master viscometers calibrated according to this practice, an operator can calibrate kinematic viscometers in accordance with Specifications D446.

5.3 Using viscosity oil standards established in this practice, an operator can calibrate kinematic viscometers in accordance with Specifications D446.

SDO ASTM: ASTM International
Document Number D2162
Publication Date April 1, 2021
Language en - English
Page Count 8
Revision Level 21
Supercedes
Committee D02.07
Publish Date Document Id Type View
April 1, 2021 D2162-21 Revision
May 1, 2017 D2162-17 Revision
June 1, 2014 D2162-14 Revision
June 15, 2013 D2162-13 Revision
May 1, 2006 D2162-06 Revision
June 10, 1999 D2162-99E01 Revision
June 10, 1999 D2162-99 Revision
May 1, 2004 D2162-99R04 Reaffirmation