Logo

ASTM D1478-11

Historical Revision

Standard Test Method for Low-Temperature Torque of Ball Bearing Grease

$83.00

$83.00

$149.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


...

1.1 This test method covers the determination of the extent to which a grease retards the rotation of a slow-speed ball bearing by measuring starting and running torques at low temperatures (below 20°C (0°F)).

1.1.1 Torque measurements are limited by the capacity of the torque-measuring equipment.

Note 1—When initially developed, the original dynamometer scale limited the torque capacity to approximately 30 000 g·cm; the original dynamometer scale is obsolete, however. The suggested replacement scale has not been evaluated; it could extend the limit to approximately 75 000 g·cm.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only. The exception is torque values that are given in cgs-metric units, which are universally used in grease specifications.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard and warning statements, see 6.1.1, 7.2, 7.4, 8.7, and 8.11.

This test method was developed using greases having very low torque characteristics at 54°C (65°F). Specifications for greases of this type commonly require testing at this temperature. Specifications for greases of other types can require testing at temperatures from 75 to 20°C (100 to 0°F).

This test method has proved helpful in the selection of greases for low-powered mechanisms, such as instrument bearings used in aerospace applications. The suitability of this test method for other applications requiring different greases, speeds, and temperatures should be determined on an individual basis.

Test Method D4693 may be better suited for applications using larger bearings or greater loads. However, greases having such characteristics that permit torque evaluations by either this test method or Test Method D4693 will not give the same values in the two test methods (even when converted to the same torque units) because the apparatus and test bearings are different.

SDO ASTM: ASTM International
Document Number D1478
Publication Date May 1, 2011
Language en - English
Page Count 7
Revision Level 11
Supercedes
Committee D02.G0.05
Publish Date Document Id Type View
May 1, 2020 D1478-20 Revision
June 1, 2018 D1478-18 Revision
May 1, 2011 D1478-11R17E01 Revision
May 1, 2011 D1478-11 Revision
July 15, 2007 D1478-07 Revision
Nov. 10, 2002 D1478-02 Revision
Jan. 1, 1997 D1478-91R97 Reaffirmation