Logo

ASTM D1353-13(2021)

Current Reaffirmation

Standard Test Method for Nonvolatile Matter in Volatile Solvents for Use in Paint, Varnish, Lacquer, and Related Products

$61.00

$61.00

$109.80


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


...

1.1 This test method covers the determination of the nonvolatile matter in volatile solvents for use in paint, varnish, lacquer, and related products.

1.2 The following applies to all specified limits in this standard; for purposes of determining conformance with this standard, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 For hazard information and guidance, see the supplier’s Material Safety Data Sheet for materials listed in this test method.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statements, see Section 5.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


3.1 This test method describes the analytical measurement of residual matter in solvents that are intended to be 100 % volatile at 105 °C ± 5 °C. Volatile solvents are used in the manufacture of paint, varnish, lacquer, and other related products, and the presence of any residue may affect the product quality or efficiency of the process. This test method is useful in manufacturing control and assessing compliance with specifications.

SDO ASTM: ASTM International
Document Number D1353
Publication Date July 1, 2021
Language en - English
Page Count 3
Revision Level 13(2021)
Supercedes
Committee D01.35
Publish Date Document Id Type View
Feb. 1, 2013 D1353-13 Revision
June 1, 2009 D1353-09 Revision
Dec. 1, 2003 D1353-03 Revision
Dec. 10, 2002 D1353-02 Revision
May 10, 2000 D1353-96R00E01 Revision
Not Available D1353-96 Revision
Not Available D1353-83E01 Revision
July 1, 2021 D1353-13R21 Reaffirmation