Logo

ASTM D1336-07

Current Revision

Standard Test Method for Distortion of Yarn in Woven Fabrics

$73.00

$73.00

$131.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This test method covers the measurement of yarn distortion of one set of yarns over the other in woven cloth following the application of surface friction. This test method especially is applicable to open-weave fabrics, such as nettings, marquisettes, gauzes, chiffons, and heavier fabrics made from slippery surface yarns.

Note 1 - For the determination of yarn slippage in woven fabrics, refer to Test Method D 434.

1.2 The values stated in SI units are to be regarded as the standard. The inch-pound units given in parentheses are provided for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


This test method is considered satisfactory for acceptance testing of commercial shipments because current estimates of between-laboratory precision are acceptable and the method has been used extensively in the trade for acceptance testing.

In cases of dispute, the statistical bias, if any, between the laboratory of the purchaser and the laboratory of the seller should be determined, with each comparison being based on testing randomized specimens from one sample of fabric.

This test method is used as an indication of the propensity of yarns to shift or distort in a fabric. Such distortions are objectionable due to the resulting changes in appearance. These appearance changes are sometimes referred to as finger marks or shift marks.

It is recommended that fabrics be tested in their original condition and also after laundering or drycleaning, or both, depending upon the intended use of the material.

SDO ASTM: ASTM International
Document Number D1336
Publication Date July 1, 2007
Language en - English
Page Count 4
Revision Level 07
Supercedes
Committee D13.59
Publish Date Document Id Type View
July 1, 2007 D1336-07 Revision
Sept. 10, 1997 D1336-97 Revision
July 1, 2019 D1336-07R19 Reaffirmation
July 1, 2015 D1336-07R15 Reaffirmation
May 1, 2011 D1336-07R11 Reaffirmation
Sept. 10, 1997 D1336-97R03 Reaffirmation