Logo

ASTM C980-88(2007)

Historical Reaffirmation

Standard Specification for Industrial Chimney Lining Brick

$73.00

$73.00

$131.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This specification covers solid kiln fired brick made from clay, shale, or mixtures thereof suitable for use in masonry construction in contact with the chemicals present in flue gases found in industrial chimneys. These brick are normally used with chemical-resistant mortars.

1.2 The physical and chemical properties of chimney lining brick differ from supplier to supplier mainly because their composition is determined by the source of raw materials. Chimney lining brick, regardless of these differences, are considered to be of three types noted as follows:

1.2.1 Type I - For use where low absorption and high acid resistance are not major factors.

1.2.2 Type II - For use where lower absorption and higher acid resistance are required.

1.2.3 Type III - For use where lowest absorption and highest acid resistance are required. Note 1 - Types I, II, and III may not differ significantly in their resistance to thermal shock, and selection of brick type should be based upon their absorption and acid-resistant service requirements.

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


This specification covers solid kiln fired brick made from clay, shale, or mixtures thereof suitable for use in masonry construction in contact with the chemicals present in flue gases found in industrial chimneys. These brick are normally used with chemical-resistant mortars. Chimney lining bricks are classified according to types: Types I, II, and III. The following test methods shall be performed for the materials to meet the specified requirements: sulfuric acid boil test: compressive strength test; water absorption; sizes; warpage; and texture.


SDO ASTM: ASTM International
Document Number C980
Publication Date June 1, 2007
Language en - English
Page Count 3
Revision Level 88(2007)
Supercedes
Committee C15.02
Publish Date Document Id Type View
June 1, 2023 C0980-23 Revision
June 1, 2017 C0980-17 Revision
Dec. 15, 2013 C0980-13A Revision
June 1, 2013 C0980-13 Revision
Aug. 1, 2010 C0980-10 Revision
June 1, 2007 C0980-88R07 Reaffirmation
Jan. 1, 2001 C0980-88R01 Reaffirmation
Jan. 1, 2001 C0980-88R95E01 Reaffirmation