Logo

ASTM C587-04(2018)

Historical Reaffirmation

Standard Specification for Gypsum Veneer Plaster

$73.00

$73.00

$131.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This specification covers calcined gypsum mixed at the mill with other ingredients to control working quality and setting time; specifically designed as a veneer plaster to be applied over gypsum base for veneer plasters, masonry or concrete surfaces to a maximum thickness of 1/4 in. (6.4 mm) providing a surface ready for decoration.

Note 1: Specification C843 contains application procedures for gypsum veneer plaster.

1.2 This specification covers test methods for determining the physical properties of gypsum veneer plasters and sets forth minimum requirements that must be met.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes shall not be considered as requirements of the standard.

1.5 The following safety hazards caveat applies only to the Test Methods portion, Section 5 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


This specification covers calcined gypsum mixed at the mill with other ingredients to control working quality and setting time; specifically designed as a veneer plaster to be applied over gypsum base for veneer plasters, masonry or concrete surfaces, providing a surface ready for decoration. In addition, this specification covers test methods for determining the physical properties of gypsum veneer plasters. Veneer plasters shall be tested and shall conform to specified values of joint strength, bond strength, impact strength, and flexure.


SDO ASTM: ASTM International
Document Number C587
Publication Date Oct. 1, 2018
Language en - English
Page Count 3
Revision Level 04(2018)
Supercedes
Committee C11.01
Publish Date Document Id Type View
Oct. 1, 2024 C0587-24 Revision
Dec. 1, 2004 C0587-04 Revision
Oct. 10, 2002 C0587-02 Revision
Oct. 10, 1997 C0587-97E01 Revision
Oct. 10, 1997 C0587-97 Revision
Not Available C0587-68 Revision
Oct. 1, 2018 C0587-04R18 Reaffirmation
April 1, 2014 C0587-04R14 Reaffirmation
Nov. 1, 2009 C0587-04R09 Reaffirmation