Logo

ASTM C395-01(2006)

Historical Reaffirmation

Standard Specification for Chemical-Resistant Resin Mortars (Withdrawn 2021)

$73.00

$73.00

$131.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This specification covers the requirements for chemical-resistant resin mortars for bonding chemical-resistant brick or tile. Mortars of this group generally have better physical properties and resist a wider variety of chemicals than inorganic mortars. For the use of these materials, see Practice C 399. Note 1Resin mortars and grouts are differentiated as follows: resin mortars are troweled onto the brick or tile, in sufficient quantity to achieve a 1/8-in. (3-mm) thick joint after the brick or tile are laid in place (buttering or bricklayer's method). Resin grouts are applied to the joints, generally 1/4in. (6 mm) wide, after the brick or tile are set in place and the setting bed has hardened (grouting or tilesetter's method). Refer to Specification C 658.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


This specification covers the requirements for chemical-resistant resin mortars for bonding chemical-resistant brick or tile. Mortars of this group generally have better physical properties and resist a wider variety of chemicals than inorganic mortars. The liquid resin may be phenolic, furan epoxy, polyester, vinyl ester, or some other resinous material capable of forming a chemical-resistant mortar when mixed with a suitable setting agent and filler. The fillers may be silica, carbon, or some other chemical-resistant material. The setting agents may include amines, polyamides, peroxides, acids or other reactants. Setting agents may be supplied as a separate component to be incorporated into the resin and filler at the time of mixing or may be supplied as a constituent of the filler. The resin shall be tested and should conform to the specified values of viscosity, chemical resistance, working life and setting time, tensile strength, compressive strength, bond strength, shrinkage, and absorption.


SDO ASTM: ASTM International
Document Number C395
Publication Date Sept. 15, 2006
Language en - English
Page Count 2
Revision Level 01(2006)
Supercedes
Committee C03.02
Publish Date Document Id Type View
Dec. 1, 2024 C0395-24 Revision
Aug. 1, 2012 C0395-01R12 Revision
May 10, 2001 C0395-96 Revision
May 10, 2001 C0395-01 Revision
Sept. 15, 2006 C0395-01R06 Reaffirmation