Logo

ASTM C1103-14

Historical Revision

Standard Practice for Joint Acceptance Testing of Installed Precast Concrete Pipe Sewer Lines

$73.00

$73.00

$131.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This practice covers procedures for testing the joints of installed precast concrete pipe sewer lines, when using either air or water under low pressure to demonstrate the integrity of the joint and the construction procedures. This practice is used for testing 27-in. and larger diameter precast concrete sewer lines utilizing rubber gasket sealed joints.

Note 1: The user of this practice is advised that methods described herein may also be used as a preliminary test to enable the manufacturer or installer to demonstrate the condition of sewer pipe prior to delivery.

1.2 This practice is the inch-pound companion to Practice C1103M; therefore, no SI equivalents are presented in the practice.

Note 2: The owner shall specify the following: who will conduct, observe, and furnish labor, material, and measuring devices and pay for the tests; who is responsible for determining local ground conditions; and whether an air or water test is to be used.

Note 3: The user of this practice is advised that test criteria presented in this practice are similar to those in general use. Pipe shall be accepted by infiltration or exfiltration testing utilizing Practice C969.

Note 4: Test times tabulated and the rate of air loss in this practice are based on successful testing of installed pipelines. However, since air and water have different physical properties, retests of some pipelines not meeting field air tests have been successful when tested with water.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautions are given in Section 6.


5.1 This is not a routine test. The values recorded are applicable only to the sewer being tested and at the time of testing.

SDO ASTM: ASTM International
Document Number C1103
Publication Date Nov. 15, 2014
Language en - English
Page Count 2
Revision Level 14
Supercedes
Committee C13.09
Publish Date Document Id Type View
Oct. 1, 2022 C1103-22 Revision
Jan. 1, 2019 C1103-19 Revision
Nov. 15, 2014 C1103-14 Revision
Nov. 1, 2003 C1103-03 Revision
Aug. 10, 2002 C1103-02 Revision
June 1, 2009 C1103-03R09 Reaffirmation
Jan. 1, 2000 C1103-94R00 Reaffirmation