Logo

ASTM B946-23

Current Revision

Standard Test Methods for Surface Roughness of Powder Metallurgy (PM) Products

$61.00

$61.00

$109.80

$73.00

$73.00

$131.40



Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


...

1.1 These test methods cover measuring the surface roughness of powder metallurgy (PM) products at all stages of manufacturing from green compact to fully hardened finished component.

1.2 These test methods provide the definition and schematic of some common surface roughness parameters (Ra, Rt, and RzISO)

1.3 This standard specifies two different standardized procedures for measuring the surface roughness of PM parts.

1.3.1 Method 1 uses a conical stylus and a Gaussian filter.

1.3.2 Method 2 uses a chisel (knife) edge stylus.

1.3.3 Each test method results in a different measure of surface roughness and the results are not directly comparable.

1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


3.1 The surface roughness of PM parts is an important characteristic in relation to factors such as their load-bearing, wear, sealing, sliding, adhesion, electrical contact, and lubricant retention properties.

3.2 Surface roughness may also be critical for component assembly or system performance. Dimensional fit and mating surface interaction may require certain surface roughness requirements to meet performance specifications.

SDO ASTM: ASTM International
Document Number B946
Publication Date Feb. 1, 2023
Language en - English
Page Count 4
Revision Level 23
Supercedes
Committee B09.05
Publish Date Document Id Type View
Feb. 1, 2023 B0946-23 Revision
May 1, 2011 B0946-11 Revision
June 1, 2006 B0946-06 Revision
April 1, 2016 B0946-11R16 Reaffirmation
Dec. 1, 2010 B0946-06R10 Reaffirmation