Logo

ASTM A829/A829M-00

Historical Revision

Standard Specification for Alloy Structural Steel Plates

$73.00

$73.00

$131.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This specification covers structural quality alloy steel plates.

1.2 The plates are usually specified to chemical composition requirements, but tensile properties may also be specified.

1.2.1 When tensile properties are required, the specific requirements must be compatible with the chemical composition, condition, and plate thickness.

1.3 The plates are available in the following four conditions:

1.3.1 Condition AR--As rolled (hot rolled),

1.3.2 Condition A--Annealed,

1.3.3 Condition N--Normalized, and

1.3.4 Condition NT--Normalized and tempered.

1.4 The plates are available in the following three forms:

1.4.1 Form I--Rectangular,

1.4.2 Form II--Circular and semi-circular, and

1.4.3 Form III--Sketch, including rings.

1.5 The plates are available in the following five edge categories:

1.5.1 Edge 1--Mill edge,

1.5.2 Edge 2--Universal mill edge,

1.5.3 Edge 3--Sheared edge,

1.5.4 Edge 4--Gas cut edge, and

1.5.5 Edge 5--Special cut edge.

1.6 The plates are available in the following seven finishes:

1.6.1 Finish 1--As rolled (hot rolled),

1.6.2 Finish 2--Blast cleaned,

1.6.3 Finish 3--Blast cleaned and oiled,

1.6.4 Finish 4--Pickled,

1.6.5 Finish 5--Pickled and oiled,

1.6.6 Finish 6--Painted, one prime coat, and

1.6.7 Finish 7--Painted, one prime coat and one finish coat.

1.6.8 The plates are usually specified to have Finish 1.

1.7 Supplementary requirements are provided for additional requirements that may be specified on the order.

1.8 When the steel is to be welded, it is presupposed that a welding procedure suitable for the grade of steel and intended use or service will be utilized. See Appendix X 3 of Specification A6/A6M for information on weldability.

1.9 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.


SDO ASTM: ASTM International
Document Number A829
Publication Date Sept. 10, 2000
Language en - English
Page Count 4
Revision Level 00
Supercedes
Committee A01.02
Publish Date Document Id Type View
March 15, 2017 A0829_A0829M-17 Revision
May 1, 2014 A0829_A0829M-14 Revision
Nov. 15, 2011 A0829_A0829M-11 Revision
Sept. 1, 2006 A0829_A0829M-06 Revision
March 1, 2004 A0829_A0829M-04 Revision
Sept. 10, 2000 A0829_A0829M-00 Revision