Logo

ASTM A684/A684M-06

Historical Revision

Standard Specification for Steel, Strip, High-Carbon, Cold-Rolled

$73.00

$73.00

$131.40


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This specification covers cold-rolled, high-carbon strip. It is furnished in the following types as specified:

1.1.1 Soft spheroidized annealed high-carbon steel is intended for applications requiring maximum cold forming. It is normally produced to give the lowest maximum Rockwell hardness for each grade.

1.1.2 Soft annealed high-carbon steel is intended for applications requiring moderate cold forming. It is produced to a maximum Rockwell hardness.

1.1.3 Intermediate hardness high-carbon steel is intended for applications where cold forming is slight or a stiff, springy product is needed, or both. It is produced to specified Rockwell hardness ranges, the maximum being higher than obtained for the annealed type.

1.1.4 Full hard high-carbon steel is intended for flat applications. It is produced to minimum Rockwell hardness requirements, which vary with grade, microstructure and gage. Full hard can be produced with either a pearlitic or spheroidized microstructure or a mixture of both. The minimum hardness should be established between the consumer and the producer.

1.2 This specification is applicable for orders in either inch-pound units or SI units.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two system may result in non-conformance with the standard.


This specification covers cold-rolled, high-carbon strip. The strip shall be furnished cold rolled spheroidized annealed, soft annealed, intermediate hardness, or full hard, as specified. The heat or cast analysis shall conform to that specified requirement. Hardness test and bend test shall be made to conform to the requirements specified.


SDO ASTM: ASTM International
Document Number A684
Publication Date Oct. 1, 2006
Language en - English
Page Count 4
Revision Level 06
Supercedes
Committee A01.19
Publish Date Document Id Type View
Oct. 15, 2024 A0684_A0684M-24 Revision
May 1, 2017 A0684_A0684M-17 Revision
Nov. 1, 2015 A0684_A0684M-15 Revision
Oct. 1, 2014 A0684_A0684M-14 Revision
May 1, 2012 A0684_A0684M-12 Revision
Oct. 1, 2010 A0684_A0684M-10A Revision
May 1, 2010 A0684_A0684M-10 Revision
Oct. 1, 2008 A0684_A0684M-08 Revision
Oct. 1, 2006 A0684_A0684M-06 Revision
Nov. 10, 2002 A0684_A0684M-86R02 Reaffirmation
Sept. 10, 1998 A0684_A0684M-86R98 Reaffirmation