Logo

ASTM A662/A662M-17(2024)

Historical Reaffirmation

Standard Specification for Pressure Vessel Plates, Carbon-Manganese-Silicon Steel, for Moderate and Lower Temperature Service

$61.00

$61.00

$109.80


Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

Document Preview Not Available...

1.1 This specification2 covers three grades of carbon-manganese-silicon steel plates intended primarily for service in welded pressure vessels where improved low temperature notch toughness is important.

1.2 The maximum thickness of plates is limited only by the capacity of the composition to meet the specified mechanical property requirements.

1.3 For plates produced from coil and furnished without heat treatment or with stress relieving only, the additional requirements, including additional testing requirements and the reporting of additional test results, of Specification A20/A20M apply.

1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


This specification covers three grades, Grades A, B, and C, of carbon-manganese-silicon steel plates intended primarily for service in welded pressure vessels where improved low temperature notch toughness is important. The maximum thickness of plates is limited only by the capacity of the composition to meet the specified mechanical property requirements. The steel shall be killed and the plates shall undergo heat treatment. Tensile properties such as tensile strength, yield strength and elongation shall be determined by subjecting the steel plates to a tension test.


SDO ASTM: ASTM International
Document Number A662
Publication Date Aug. 15, 2024
Language en - English
Page Count 3
Revision Level 17(2024)
Supercedes
Committee A01.11
Publish Date Document Id Type View
Nov. 1, 2017 A0662_A0662M-17 Revision
May 1, 2012 A0662_A0662M-12 Revision
Sept. 10, 2003 A0662_A0662M-03 Revision
Sept. 10, 2001 A0662_A0662M-99 Revision
Sept. 10, 2001 A0662_A0662M-01E01 Revision
Sept. 10, 2001 A0662_A0662M-01 Revision
Aug. 15, 2024 A0662_A0662M-17R24 Reaffirmation
Nov. 1, 2007 A0662_A0662M-03R07 Reaffirmation