Logo

ASTM A285/A285M-03(2007)

Historical Reaffirmation

Standard Specification for Pressure Vessel Plates, Carbon Steel, Low- and Intermediate-Tensile Strength

$73.00

$73.00

$131.40

$0.00

$0.00

$0.00



Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


Stay effortlessly up-to-date with the latest standard revisions. When new versions are released, they're automatically charged and delivered to you, ensuring seamless compliance.

...

1.1 This specification covers carbon steel plates of low- and intermediate-tensile strengths which may be made by killed, semi-killed, capped, or rimmed steel practices at the producer's option. These plates are intended for fusion-welded pressure vessels.

1.2 Plates under this specification are available in three grades having different strength levels as follows:

Grade Tensile Strength, ksi [MPa]
A 4565 [310450]
B 5070 [345485]
C 5575 [380515]

1.3 The maximum thickness of plates under this specification, for reasons of internal soundness, is limited to a maximum thickness of 2 in. [50 mm] for all grades.

Note 1—For killed carbon steels only refer to the following ASTM specifications:

A 299/A 299M Pressure Vessel Plates, Carbon Steel, Manganese-
Silicon.

A 515/A 515M Pressure Vessel Plates, Carbon Steel, for
Intermediate- and Higher-Temperature Service

A 516/A 516M Pressure Vessel Plates, Carbon Steel, for Moderate-
and Lower-Temperature Service.

1.4 For plates produced from coil and furnished without heat treatment or with stress relieving only, the additional requirements, including additional testing requirements and the reporting of additional test results, of Specification A 20/A 20M apply.

1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.


This specification covers carbon steel plates of low- and intermediate-tensile strengths which may be made by killed, semi-killed, capped, or rimmed steel. These plates are intended for fusion-welded pressure vessels. Plates are normally supplied in the as-rolled condition. The steel shall conform to the required chemical compositions. The plates, as represented by the tension test specimens, shall conform to the mechanical property requirements.


SDO ASTM: ASTM International
Document Number A285
Publication Date Nov. 1, 2007
Language en - English
Page Count 3
Revision Level 03(2007)
Supercedes
Committee A01.11
Publish Date Document Id Type View
Oct. 15, 2024 A0285_A0285M-24 Revision
Nov. 1, 2017 A0285_A0285M-17 Revision
May 1, 2012 A0285_A0285M-12 Revision
Sept. 10, 2003 A0285_A0285M-03 Revision
Sept. 10, 2001 A0285_A0285M-90R96E01 Revision
Sept. 10, 2001 A0285_A0285M-01 Revision
Nov. 1, 2007 A0285_A0285M-03R07 Reaffirmation
Sept. 10, 2001 A0285_A0285M-90R01 Reaffirmation